Interested to Buy Any Domain ? << Click Here >> for more details...
What happens when the field of an alternator connected to
infinite bus is suddenly removed?
- 3 Answers
- 7077 Views
- I also Faced
- E-Mail Answers
Answer Posted / niranajn
when the field is removed the alternator will act as an
induction motor
| Is This Answer Correct ? | 3 Yes | 6 No |
Post New Answer View All Answers
circuit diagram of trip circuit supervision relay
What are operating procudures & Safety precautions to be observed while operating OLTC in manual mode ?
how can we determine size of a cable by knowing the kw or current rating of a load?how can we calculate the resistance box of a slip ring motor?
If the Brush of DC motor is shifted by 90 deg, then what happens to voltage and torque? Both voltage and torque are zero. how to justify the answer?
what is meant by twilight switches 7 where its applicable ?
'documenˁ
How will calculate losses in an multi core Aluminium LT cable of different sizes & upto what length we can use a LT Cable ?
what happen if generator of micro hydro running at only a small percentage of its capacity, as a comparison, if the diesel generator that runs on only a fraction of its capacity there will be a wet stacking
How many types of circuit loads are there in a common electrical circuit?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
What are marginally stable systems?
state the working of discharge lamp?
Which types of gate insttaled in static switch. Please give me answer.
Pls tell me whether we can use EN3A material for shafts of Permanent magnet alternator.What will be the effect of magnetic and nonmagnetic material for shafts on magnetic properties of PM rotor .
66kv under ground cable how to layaing in ground any special case two ckt r runing
