Answer Posted / biswapriya mazumder
mix design unlike nominal mix is the method of fixing the
proportion of the cement,sand, coarse aggregates by certain
equations based on trial and error to get the desired fck
value,where fck value is that value where not less than 5%
of the test results are expected to fall.i have seen this
method being used at a L&T site quality control department.
Is This Answer Correct ? | 11 Yes | 5 No |
Post New Answer View All Answers
What is the nature of duties & responsibilites senior civil engineer ?what is self confident & satisfaction should be a senior civil engineer?
punj loyed and sapurjl palanjl
a solid steel rod length 2m dia and 20mm vertically hangs from celling and has a collar firmly atteched to it. above the collar an annular rubber washer of 40mm th. having stifness k = 5n/mm is placed. determine maximum stress in the rod caused by mass of 5 kg falling through a height of 1.2m.
Basic questions of civil engineering
Requirement of cement, and steel 1:2:4 ratio concrete in 1128 Sqft area(Cement No of bags, steel in Kgs)
How much the quantity of Dry material of Crush for 1:2:4 Concrete, using pan 3/8'' down....
how to calculate the rebar depth if forgot the foundation reinforcement (main steel)? is that any calculation or formula we have data sheet of supplier what depth what is the pull out capacity is mensioned in data sheet. if any IS code than its help full to me.
Are cruise ships built for the transatlantic run?
What is the method of soil replacement test?
difference between trapezoidal and pedestal footing and how the load acts on that
what is yield and tensile strength of steel, if steel has yeilding strength of 60 psi than how much its tensile strength?
what is the service corridor?
how to caliculate required amount of cement and sand required for 1cu.m.
Which is the latest version of solidsworks?
WHAT R THE GENERAL TECH QUESTIONS ASKED FOR THE INTERVIEW FOR AN AUTOMOBILE INDUSTRY,SPECIALLY DESIGN DEPT