Answer Posted / anil kamat
fine tuning the feed, speed, depth of cuts,number of
movements before the required depth of cut is achieved ,
incremental feed rate, automated tool wear compensation etc.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
What parameters to be reported when we send lubricating oil for shore analysis?
If you have a valve with an applied pressure, how do you determine the stress to the closed and open valve?
What is general pressure ratio for axial, reciprocating and centrifugal compressors?
If mft not act when spark failure 3 time what problem will happen in boiler side
where can i get railway junior engineer(mechanical) previous years question papers?
Name the four most important components of a Freon refrigeration system.
Which reactor uses heavy water as moderator ?
where the compressor is placed in the automobile?
What do you know about DG ,A,B,C, D, Check and safety of generator.?
Describe The Complete actvities of the STORE KEEPER?
What are the properties of fuel oil?
What is the use of rasp file?
What is isotropic material ?
Name the sheet metal hand tools?
what is difference between british wire guage & birmingham wire guage
