Why the airgap of an induction motor is less compared to
that of a synchronous machine?
- 4 Answers
- 28433 Views
- MGVCL, RRB, WebTech, I also Faced
- E-Mail Answers
Answer Posted / arunkumar
as the stability critera is main in the synchronous m/c
the air gap length is more even though size and weight
increases with redused power factor ,where as there is no
stability criteria to be satisfied in I/M more
concentration is taken for power factor inprovement by
providing less air gap
| Is This Answer Correct ? | 21 Yes | 3 No |
Post New Answer View All Answers
I have doubt that the supply HZ (very low or high than rated ) may affect the power factor. is it true. ?
for 100 HP Induction motor service factor is 1.2(SF) we placed a VFD at the motor side load is balance with 0.3 Amp's Phase to Phase but at incoming of VFD load is un-balance with 10 to 20 Amp's what will be cause of load un balance
Can a generator runs after getting 1st stator earth fault.
Explain what is use of lockout relay in ht voltage?
what is the range of maximum DOL and SDS can be use for pump and fan application
How they LT panel busbar size choose
How servo stabilizer works.
I am having a 1500 KVA transformer whose secondary current is 2086A and my connected load is 1000 KVA, I am having 400 KVAR APFCR for PF improvement what ratio of CT should i install in LT EB Bus to get optimum PF improvement?
what is the principle of operation of tungstun bulb ??
As per standard, transformer body earthing and other Equipment earthing (Equipment earthing) did not connect. but in LT side termination we are doing metal glanding in both side Transformer to PCC Panel through armoured cable, now X'mer body earthing and PCC Pane earthing (Equipment earthing) both are connect.is this safe for X'mer or other equipment?
What is meant by Load Encroachment in OHL Feeder Protection?
What is difference between insulating medium and fault current interruption medium in a switching device.
Distribution transformer we provided 2 separate earthing pit for Body and 2 separate earthing pit for neutral,we can not connect separate body earthing pit to other earthing pit but we do metal glanding in secondary side cable termination in both side, transformer and PCC panel (LT Panel), is this safe for transformer and other equipment?
how hazordious area is classified at an oil & gas plant and categorise suitable class of electric equipment in that area like induction motors, LCS, Lighting Fixtures Fluerescent/Flood lights Mercury& sodium lights, J.Bs, Power Cables etc
briefly explain the main blocks found in a microprocessor based system
