WHAT IS THE FULL FORM OF CABLE TYPE-AYWY,AYWAY,YWY ?
- 6 Answers
- 92483 Views
- Polycab, VIR, XLPE, I also Faced
- E-Mail Answers
Answer Posted / sushanta
Alluminium PVC innsulated steel armour round armoure wire
PVC outer sheet.
| Is This Answer Correct ? | 37 Yes | 18 No |
Post New Answer View All Answers
Why wind turbines wheels rotate constantly
where is core-type and shell-type construction suitable for transformers ?
what is meant by CT`s saturation ? Can we use Metering CT`s with Protetection CT`s ?
explain the types of drives
What is an alternator impedance value?
what is difference between 9kv 5ka surge arrester and 9kv 10ka surge arrester.
What is limitedly stable system?
Hi My dear all Friends, There is a question regarding HVAC Engineering and widely used in Power Projects. Question- What is the diffrence Between REF, SEF and Differential Protection....???? Where REF - Restricted Earth Fault SEF - Senstive Earth Fault.
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
What is the function of attenuator in cro?
Mention the methods for starting an induction motor?
how the characterstics of control valve being done
which model T or pie model is prefarable in power syatem
what about SAP/MRP regarding manufacturing of electric motors and all drives?
What is the difference between Delta & Wye windings?
