Interested to Buy Any Domain ? << Click Here >> for more details...
in three pin pluge there three pins one is phase and second
is earth third is nutral why nutral high diameter compare
with phase and earth
- 10 Answers
- 18846 Views
- Radiant, I also Faced
- E-Mail Answers
Answer Posted / ssnslm
Normally earth pin is larger in dia than phase and neutral,
to provide low resistance path for the flow of fault
current. We know resistance = (resistivity * length)/ c.s
area of the conductor
| Is This Answer Correct ? | 7 Yes | 3 No |
Post New Answer View All Answers
DEAR SIR,I GOT THE CALL LETTER FROM RRB, SECUNDERABD AS A JE-II SO PLEASE PROVIDE ME SOME MODEL QUESTION AND ANSWER PAPERS AND LAST YEAR QUESTION PAPERS
what are the industrail measures to over ferranti effect? how would the ferranti effect the power system if those remedial mearsure arent taken? how often does this effect occurs in real power system?
Is a 300w induction motor used in a food processor as powerful as a 1000w DC motor.
How convergengr of nr method is not dependent on selection of slack bus and how gauss siedel method depends?
please send me latest & previous years question papers for IOCL Technical level questions
How to arrange a hous hold earthing system to keep minimum earth resistance( below 7ohms).
how a flip flop can be used as a latch?
What is the approximate value of stacking factor?
I just purchased a 4 position cam switch to be used to operate a 3-speed blower motor. The motor is a 10 amp motor and has 3 wires that are used to control speed. The cam switch was rated at 660V 20 amps but when I received it, I noticed that it has AC-15 operational current rating (Ie) of 4/5 amps. If I am reading the label correctly. the 4/5 amps is related to 440v/220V (Ue). Other ratings are AC-3: 5.5A, AC2: 7.5A and AC-4: 1.5A. My questions are 1) Is it safe to use this switch with the motor I have 2) what is the difference between the 20 amp Ith ratting and the Ie operational ratings?
in science exhibition how lamp can blink when you clap near the lamp ? thank you
What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer?
why does make gain margin and phase margin on same plot.?
WHY NUTRAL GROUND SYSTEM USED IN 33KV SYSTEM
plz send me Bhel, Mahagenco, sbi previous exam paper for electrical engineer on my email-id kambali_smita@yahoo.co.in
wish of these transformer uses oil?
