You have powered on a new router and you want to create an
initial configuration. Which mode should you use?
A. copy mode
B. user mode
C. setup mode
D. startup mode
- 4 Answers
- 6154 Views
- Enrich, I also Faced
- E-Mail Answers
Answer Posted / kunal
for intial configuration on fresh router it require setup
mode so C would be correct answer.
A copy mode is nothing but used copy cmd in tftf flash
copying ios.
B user mode is for showing utilities and restricted
permissions
D.startup mode is used basic start up[ configuration..well
cisco determines basically 4 modes
1.user mode
2global config mode
3.privilage mode and
4 set mode thats all
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
Which feature should a routing protocol have to support vlsm?
What are the conversion steps of data encapsulation?
Value in which type of access list?
Referring to the commands shown, what command must next be used on the branch router prior to traffic being sent to the router?
What is BootP?
What are the netbios and netbeui?
What are 10base5 ethernet lans?
Why we use debug command?
How can you assign a vlan to a switch port?
Can you explain PAP?
What are the advantages of a layered model in the networking industry?
Who controls mac address uniqueness and how?
Mention the conversion steps of data encapsulation?
Hi Friend. i have to let you know that now i have been selected for cisco india in bangalore. i am thanking to all of you guys that u have been posted such good question and the respective answer. from today i will be not able to visit this site on regular basic and hopeing that you will continue to post the question.the question you are posting is not very usefull to you but also usefull to another. i am again thanking to all of you and hope for best for your feature. Jitendera kumar sinha Network engineer-L2 cisco india Bangalore
What’s the easiest way to remotely configure a router?
