Interested to Buy Any Domain ? << Click Here >> for more details...
wat is the difference between real power and reactive
power..which is useful..?and how it s useful..wat is the
effect of these on a power system...
- 10 Answers
- 23822 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / nithya
reactive power is actually a useful power,which is used for
boosting up of voltages,it is the stored energy...
(capacitors),injection of reactive power is necessary at
some cases.
| Is This Answer Correct ? | 20 Yes | 29 No |
Post New Answer View All Answers
Explain the following and how these are working with PLC Unit 1 I/O Module Card 2 Adaptor Card 3 Ribbon Adaptor 4 I/O bus 5 I/O Devices
CAN WE CALCULATE THE NEGATIVE SEQUENCE AND ZERO SEQUENCE REACTANCE OF A GENERATOR USING ONLY ITS RATED VOLTAGE, KW, PF AND SYNCHRONOUS REACTANCE??? IF YES, THEN HOW??
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
what reason of line current and phase current in star connection and line current and phase current not equal in delta connection?
1. If 8.35%Z means the percentage impedance of 132kV-line from power company, we will like to confirm its base capacity?
What are the advantages and disadvantages of the dc motors?
State Maximum Power Transfer theorem.
delta motor winding resistance I take normally single winding is 2.5, which value is came delta connection ie RY ?
How can we choose the rating of submersible motors
Which is the largest hydropower station in the world?
what is the sludge current
explain all the classes with example
why Lightening Arrester Probe sharp at Top of telecom tower.
Why using synchronising methed in DG's sets?
In the formula : Knee point voltage = Burden X alf / class, Please inform what is alf? regards Shashidhar M.R.
