Interested to Buy Any Domain ? << Click Here >> for more details...
Explain why machinery used on a.c supply is usually rated
in KVA instead of KW?
- 10 Answers
- 22559 Views
- EEE, Mtandt, I also Faced
- E-Mail Answers
Answer Posted / sugankumar
in ac machines the iron loss is depends on voltage(V)...
and the cu loss depends on current(I).... so the total
power depends on KVA.... in DC the voltage and current
depends on cu loss only so the DC power is calculated in
KW......
| Is This Answer Correct ? | 19 Yes | 7 No |
Post New Answer View All Answers
In India the supply voltage is 230 volt A.C. During the negative half cycle phase becomes neutral and neutral become phase? or what will happen during negative half cycle? how the electrons flow during positive and negative half cycle?
why power factor is important?
Is there any abbrevation for STUB in Stub bus protection
why ten delta testing is carried out on power transformer
describe the constructional features of an auto transformer and its principle operation
What is the function of retrip in busbar?
why ahould you show client/engineer activities clearly on the project plan
In Dyn11 power transformer if any one of the 3 phases connected to earth in star connected side then please explain effect of the current flow in delta connected side of transformer.(In this case if one phase is shorted to ground in star connected side then we observe the current flow in two phases only not three phases in delta connected primary side. Please explain why it is so?)
What is the difference between relays and contactor construction wise?
what is the calculation involved to design the heater to heat 10KL of water in temperature control unit?
I have been using an 600VA with 0.6 p.f UPS with my desktop which has 450W power supply unit. Can anyone explain how can this happen . Because the output of the UPS is 360W (600*0.6) (<450W)
why Current is lead 90 degree and voltage is lag 90 degree in a capacitor.? why Current is lag 90 degree and voltage is lead 90 degree in an inductor.?
what is rocking arrangement in arc heating
how we can come to know that motor winding resistance which showing by DMM is right or wrong???is there any chart or something that we will compare & check???
plz send me the placement interview question and answers of whizchip(technical and apttitude)..i have an interview in next.
