Interested to Buy Any Domain ? << Click Here >> for more details...
when any relay trips in any ckt then what type of setting is
there in motor?what is function of relay in that ckt?
- 3 Answers
- 8179 Views
- Finolex, I also Faced
- E-Mail Answers
Answer Posted / sath
relays are classified into
under current, voltage, power relay,
over current, voltage, power relay,
distance relay,
directional or reverse current relay,
differential relay.
based on any one of the catageries the relay will
operate.Based on the application of the motor relay will
selected.
These are the device which direct the abnormal condition in
the electrical system by measuring the electrical quantity
like voltage, current, frequency, phase angle.Due the
abnormal condition any one of the above mentioned values
are changed.After detecting the fault relay will complete
the trip circuit and energised the circuit breaker.Hence
isolate the fault current.
| Is This Answer Correct ? | 8 Yes | 0 No |
Post New Answer View All Answers
why we used dc supply for field in dg set
What is purpose of reactor?.What is different between line and bus reactor?
Differentiate between real and apparent power?
we have 15 ampere variyac but we want 30 ampere variyac what we do
why magnetising curve not start with zero voltage?
Can we test the alignment of End shield and stator of turbogenerator without rotor insertion? Also how to fix maintain the alignment at site installation?
How to Calculate The sag of OPGW in Transmission Line???
What is the difference between cylindrical-type and sandwich-type winding?
Pls explan the OLR setting in VCB at HT yard
what is JE exam?
What is the difference between a Root Locus plot and a Bode plot?
Is it required to lay GI wires along with GI/MS conduits from one point to another point though separate earthing cable is conncted from DB to Socket?
What should be the voltage between Neutral and Ground in secondary side of the step down transformer (230 V to 110 V) with no load condition?
how can we save enegry by using VFD for Resiprocating Air compressor which is having more unloading running hours
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
