what is the earthing condition between earth & neutral.
- 6 Answers
- 9396 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / glen
if you see the voltage level between earth and neutral is
approx 2to3v
this is becoz
earth is at potential zero
but neutral is not at exact zero
it is zero volt with respect to phase but is floating with
respect to earth
| Is This Answer Correct ? | 26 Yes | 0 No |
Post New Answer View All Answers
what is sevice settings for mccb?How can be it setted?
While performing stability test of differintial cts how to know the voltage and current on both side of the transformer?
What will be the fault current of any system when its generation is 10% of BASE generation( FUll Load )?Will is 10% or the same as full base calculation?
high voltage transformer input voltage,current and amps rating..distributed transformer input voltage,current and amps rating...
What is the need of earthing transformer for delta side of a transformer. (Think of a line section between a star/delta transformer at a grid substation and delta/star transformer at a village. An earthing transformer is there at the delta side of the star/delta transformer at grid substation). As there are no ground reference there will not be fault current if a one phase is grounded. Further L-L phase will be sensed by the primary side of star/delta transformer as a L-G fault. So why an earthing transformer is required at delta side
In a single how much maximum current and watts using
Is a 300w induction motor used in a food processor as powerful as a 1000w DC motor.
What is kvar?
in single phase converter, the no.of scr's conducting during overlap a)1 b)2 c)3 d)4
FOR 16/20 MVA 132/33 KV ONAN/ONAF TYPE TRANSFORMER IT IS DESIGNED FOR 16 MVA WITH ONAN CONDITION.IT BECOMES 20 MVA UNDER ONAF CONDITION.LOAD LOSS IS GUARANTEED FOR 65KW AT 20 MVA AND % IMPEDANCE 13.75. PLEASE TELL US AT WHAT LOAD LOSS AND % IMPEDANCE IT SHOULD BE DESIGNED FOR 16 MVA AND WHAT WILL BE ITS EFFICIENCY AT 20 MVA?
What are the advantages of hydropower?
Hello Friends, How can we recognize the CT Star Point is S1 or S2 in case of Electro Mechanical Relays and what is meant by Restraining coil in relays and what is the purpose of that.. thank you in advance..
why the pf of semiconductor device is improved the electrical devices
what is the difference between skin effect
Can we Co-ordinate relay in Load Break switch?
