HOW WOULD YOU PRESENT THE POWER FACTOR PRACTICALLY ON A
GRAPH
- 4 Answers
- 9197 Views
- Bhel, I also Faced
- E-Mail Answers
Answer Posted / moti rgpv
TO MEASURE PF PF-METER IS USE.DRAW ANGLE B/W PF AND TIME
| Is This Answer Correct ? | 5 Yes | 16 No |
Post New Answer View All Answers
What is the most important precaution in any experiment with d.c. Shunt motor?
we have 3 single phase transformers. how will we generate 6 supply from 3 phase supply input
What is a copper loss or i2r loss pc?
Make a list observation on Transformer?
Either It Possible a dc Motor to Run On Ac Drive [ Ex : ACS 800 , Yaskawa F7 ] If it is Possible How Pls Inform Me dinesh_elect_eng@yahoo.com
How we can calculate the life of Lead acid battery
An ISP is granted a block of addresses starting with 150.80.0.0/16. The ISP wants to distribute these blocks to 2600 customers as follows. a) 200 medium size businesses; each needs 16 addresses b) 400 small businesses; each needs 8 addresses c) 2000 households; each needs 4 addresses Design the subblocks and give the slash notation for each subblock. Find out how many addresses are still available after these allocations.
Why is ignitor used in sodium vapour lamp
what happens in the short circuited secondary transformer,if the resistance of the short circuit is increased gradually?
Which is the largest hydropower station in the world?
how to get bearing & winding temperature of an induction motor?
does the Trivector Meter of three phase automatically takes care of the low power factor and gives the reading accordigly or it does not take care of the Power factor while giving the readings please explain
We are preparing another project which involves Waste heat recovery from a 1 MW GE Engine. The Engine in particular gives out flue gas at 487Deg C with a flow rate of 5650 kg/hour and this can be cooled to 180 Deg C. This gives a thermal output of ~ 594 KW that is available for input to VAM via heat exchanger / boiler. Additionally 581 KW will be available from engine jacket water (temperature profile 80/ 80 Deg C and a flow rate of 50m3/hr) Our estimation is that 300 TR of cooling is possible with a suitable VAM machine(s). Please advise what is the most suitable arrangement with maximum TR and min Capital expenditure. plz reply me as early as possible
what is the operating time for LBB and how does the LBB relay realise whether cb is opened or not?
how many current required for hypo test
