what is plc?
Answer Posted / ibrahim s
PLC(Programable Logic Controller):
*It is used to emulates relay logic interlock and
provide device status.
*It works by looking at its input and depending upon
their state turning on or off its outputs.
*It control the devices according to user defined
logical
program.
| Is This Answer Correct ? | 38 Yes | 4 No |
Post New Answer View All Answers
how to change measuring units from mmwc to cubm/h in rosemount air flow transmitter with hart communicator fluke 744
How will you calibrate an Absolute Pr.Transmitter of range 400mmHg absolute ?
Pl send the model question paper of mahagenco account officer post
how to tune siemens sipart electro pneumatic positioner..plz tel me..
What is motion balance principle?
what are the definitions of input, output, command & signal according to instruments controlled by PLC using DCS System?
How servomotor controls throttle valve of TURBINE?
How is PH sensor works ?
any body please send me the old question papers of ongc test.
Please tell me details about Sox,Nox,SWAS analyser????
I am teja. I am studying Msc(tech) Electronics and Instrumentation (3years course) in Andhra university. But my course is not recognised by UGC and AICTE. Please tell me the job opportunities after this course. And i fineshed PLC course in IGIAT ,Vizag.Also complted my short term coure in SCADA, Seimans WinCC in ATI,Hyd.After Msc can i join Mtech for good job? or phd. How i can get good job in INdustrial Automation Side. Please give replay.Because this is my life matter.
PT RTD Range: -200 to 500 degree celsius If I configured in DCS Lower range and Upper range . In face plate it shows red colour due to overa range how was the characteristics look If the temperature is more than operating range. how was the characteristics look . whether its in Resistance vs Temperature curve is Linear or Non linear
Difference between 2-Valve Manifolds, 3-Valve Manifolds and 5-Valve Manifolds 3 with diagram
䑰ҕ䔈ҕ䖠ҕ䘰ҕ䛀ҕ䝐ҕ䟐ҕ䢐ҕ䥐ҕŹ
Linear amplifier.