Interested to Buy Any Domain ? << Click Here >> for more details...
wht is this amps in power consuption and how can we
convert that into consuption hours ? i am a sales executive
of a energy saving lamps .
- 5 Answers
- 8552 Views
- KSEB, I also Faced
- E-Mail Answers
Answer Posted / kumaran
Kilowatt Hours = (Watts x Hours of Operation)/1000
| Is This Answer Correct ? | 7 Yes | 1 No |
Post New Answer View All Answers
i am completed diploma in ece,and working in ht and lt lines.so is elligible diploma in ece for get electrical C Licence?plse give ur opinion?
From past few months I am getting lagging pf even though sufficient capacitors used in circuit. Where is the problem pls answer
what is servo motor and how to work it.
in dc suppy frequency is zero why? if dc frequency is zero how to exist dc transients and ac transients
What is meant by turbo alternators?
1. What is differential relay? How it operates? 2.How to calculate the Short Circuit Impedance in Transformer? 3.What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works? 4. While testing the 33KV Busbar by using Hipot kit, what should be the test voltage we have to apply? 5. What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer? 6. Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example? 7. Why restricted earth fault protection is needed? Why can’t differential Protection is sufficient? 8. What should be the minimum and maximum ohmic value for earthing? 9. Why DC Currents are not used in transformer? 10. What is the Frequency while we step up the voltage from 220V to 11KV? Is it possible? Explain it?
What are root loci?
DEFINE BREAKING CAPACITY OF BUSBAR & HOW IT IS CALCULATED?
Write down the design procedure of commutaj.
if there is nutral in phase why we use earthing wire and grounding? even at fault condition the fault current flows to neutral (it is a lower path)
How to calculate the sag on transmission Lines.
why we can use 1 to 5V dc
working of diesel generator ?
what is the ms flat constant for calculating earth mat design calculation?
dg earth connect only in the amf panel or not why
