which motor is suitable for traction? why?
- 15 Answers
- 47902 Views
- BCH, KPCL, I also Faced
- E-Mail Answers
Answer Posted / aniruddh
D.C series motor used in traction because high starting
torque & variable torque.
| Is This Answer Correct ? | 50 Yes | 6 No |
Post New Answer View All Answers
What is Load sharing of Transformer ?
Is it required to lay 2 runs of GI wires along with armoured cables from one power DB Machines of higher rating?
why actual valve timing diagram is different than ideal valve timing digram of a 4 stroke engine?
what are the stresses in circuit breakers ?
derive DC RMS value for half wave rectifier?
what is the difference between an alternator and a synchronous motor
if there are six generators (3 gas CATT, one Jenbacher o1 MW each, and two nos Diesel 01 no 01 mw other 0.65mw EDGs ( say), 3 CAtt gas set have identical pole pitch,01mw EDG and Jenbacher gas Set have different pole pitch, how their power connection can be done to connect a common bus bar during installation. in short, how different pole pitched generators power connection can be done to connect a common busbar system through generators incomer ACBs.
how point on wave controller works.
I need the list of Universities who have summer intake for BS degree in Electrical Engineering.?
What is clock position of Transformer?what are the clock positions are there?and what is different of them?
Discuss about gear cutting machines.
How can calculate the rating of a servo stabilizer for given a specific load
Brushes are placed at magnetically neutral axis,when brushes reach that point,the armature conductor gets shorted,but it can be seen that the dc supply is also shorted,wont that get damage? help me plz
In the Variable Voltage Variable Frequency Drive, how the Voltage and Frequency varied ? Is it varied in the Inverter part of the Drive ? Please give us supporting document if any.
why generator efficiency is more in swinburnes test?
