Why high voltage lines (overhead ) are called high tension
lines?
Answer Posted / prosenjit majumder
I have an answer in my mind . In high voltage power
transmission system the gap between the poles ( hold the
transmission line ) are much more than low voltage
transmission . The power cables suspend freely between
poles. As gap between two poles more the tension of
suspended cables also very high . For this reason high
voltage lines are called high tension lines.
Is This Answer Correct ? | 8 Yes | 51 No |
Post New Answer View All Answers
Define delay time.
How earthing of switchgear system to be done.
What is the meaning of Insulation H for transformers????
can I improve the furnace power factor (10 mva transformer) by adding a capacitor bank before the transformer.Does system power factor vary a lot with the furnace PF?
I have motor of 3 H.P. How i found the rating of capacitor use in it in single phase motor..???
how can get electrical c licence.now i am working in spining mill , transformer capacity 2750KVA. SANCTION DEMAND 2250KVA. PLEASE ADVISE ME . MY CONTACT NO 09944226823
In what cases (circumstances)we should apply P controller, PD controller, PI controller & PID controller ?
What types of question are done for diploma students in aptitude test
What is safety of Ht panel
what is the criteria for selecting fuse rating in 1phase, 2phase & 3phase welding sets?
number of I/O devices in siemense plc
at what basis/standard we have to arrive the current density of aluminium/ copper in busbar?
if 6 earth pit value is 1.5 ohm then what should be the number of earth pit to make the value .8 ohm
We have 5 Distribution sections with variable loads&We have 3 Gensets(500kva,380kva&250kva) our total load is between 400kva to 600kva. so how could we connect 3gensets.
What are the site acceptance tests for power cables, DG Sets, LT panels & 30kVA UPS ?