Interested to Buy Any Domain ? << Click Here >> for more details...
1.why is +1+1=+2 why cant it be +3
2.Why is +1*-1=-1 why cant it be something else
3.why are the hilly areas more cooler than the ordinary
areas?
- 5 Answers
- 7838 Views
- ThyssenKrupp, I also Faced
- E-Mail Answers
Answer Posted / amir sharif
+1+1=2....i dont know the answer
1*-1=-1....i dont know the answer
The hilly areas like ooty and kodaikanal r more cooler
because of the suns reflection, the low lying areas recieve
the suns ray first and afterwards it gets reflected, by the
time the suns ray reaches, it cools down and there is no
heat in the hilly area thats why hilly areas r more cooler
then low lying areas..
| Is This Answer Correct ? | 2 Yes | 7 No |
Post New Answer View All Answers
give some advantages and disadvantages of combiniing the session, presentation, and application layer in the osi model into one single application layer in the internet model
Why do power lines not short out when they fall into water?
2 v/500amp/hr to 1.80vpc at 20 degree celsious 2v/5ooamp/hr to 1.75 vpc at 77degree farren .this is the capacity of a battery .what is the meaning of this . can i get a detailed explenation
Explain the following and how these are working with PLC Unit 1 I/O Module Card 2 Adaptor Card 3 Ribbon Adaptor 4 I/O bus 5 I/O Devices
What is difference between safe PLC and normal PLC
please send me previose rrb junior engineer qustion papers
Explain the purpose of inductor in an electric circuit?
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The slip when motor stalls is A 1 B 0 C 13.33% D 10.33%
How to select a contactor? How many types of contactors are available
What is main cause of cable's terminal point burned in Lug on high temperature although lug and cable selection is ok as per stantard and also tightness is ok as per situation. so please take in deep and tell correct answer thanku.
difference bewteen reverse current and alternating current
magnetizer priciple
What are the basic elements used for modeling mechanical rotational system?
If UG power cable both ends are to be earthed or what? If not why?
Write masons gain formula.
