Interested to Buy Any Domain ? << Click Here >> for more details...
can induction motor run over the rated speed ?
- 12 Answers
- 18650 Views
- ACC, I also Faced
- E-Mail Answers
Answer Posted / padmanabh thakur
wheninduction motor run over synchoronous speed then it
behave as generator.
this can be done by using flux control or by external means
| Is This Answer Correct ? | 5 Yes | 2 No |
Post New Answer View All Answers
In EB metering we face problem kva jump even in no load condition.can any one help to control this
What are the limitations of Kirchoff's laws?
We have studied about many techniques for finding the stability of system, ROOT LOCUS, ROUTH, BODE PLOT, POLER PLOT etc. In these which is used where. what are the difference among them... PLZ tell me.......
Difference of induction motor & servo motor ??
Define the overload capacity of the motor?
Why does amplifier gain reduce?
ii) A shunt motor supplied at 230V, runs at 900 rpm when the current is 30A. The resistance of the armature is 0.4 ohms. Calculate the resistance required in series with the armature to reduce the speed to 600 rpm, assuming that the armature current is then 20A. [12]
TCS IS IT COMPANY THEN WHY DO THEY NEED ELECTRICAL &ELECTRONICS ENGINEERS?
We have received supplies of the ordered material. payments against the supplies also released. Where ST paid 4% against form C. Meanwhile it has been observed that 25% of material supplied was defective. Please suggest whether the issuance of C form from our side would be stopped till settlement of liabilities.
what is the ground fault relay,which purpose it will be use,clearly tell me plz
Following test should be conducted to find out relative polarity of transformenr terminals A no load test B back to back test C phasing out test D none of above
What are the disadvantages of hydropower?
Can any body tell me the different types of LT cables & their application.
what is the difference between the characteristics of two different phase bushing of any transformer
why the making current is more than then the breaking current and if its true then its about a controling circuit or breaker power contact points
