sir, I am taking jindal written test,which will be on 19th
of this month.If any body have written test paper
queatins,Plz send to this mail id.. bhaskarlxm@gmail.com
Answer Posted / dhananjay kumar
JINDAL Placement Papers
Paper Type : Whole Testpaper
Test Date : 17 February 2008
Test Location : Kolkata
JINDAL PAPER ON 17th FEBRUARY AT KOLKATA
The test of JSPL held on 17th February 2008 was more or less
of an easy type for instrumentation stream. Many questions
were from power electronics and communications. The ques
that I remember were:
Verbal (20 ques):
1. 10 ques based on two RC passages,dealing with computer
languages.
2. remaining ques on articles, prepositions and word meanings.
Numerical (20 ques):
1. all ques based on simple but lengthy calculations
involving %ages, profit and loss, ratio-proportion,etc.
Attention to detail(15 ques):
1. ques based on pattern recognition, logical reasoning and
types like if + is -, - is *, etc.
Technical (60 ques-INSTRUMENTATION):
I remember 51 ques. They are:
what does ‘value’ mean in value engg.
what is value engg used for
two ques on statement of nyquist-shannon theorem
i/p and o/p impedance of instrumentation amplifier
given open loop TF for unity f/b calc damping ratio
given G(s)H(s) calc type of system
thru which signal does µP communicate with memory
12 address lines address how much of memory
no of timers of 8051
prog device used with 8051
µcontrollers used widely in which industry
ques on what is LPP
which technique used for optimization in OR
which of these deals with reducing waiting time(ans: queuing
theory)
given BW and SNR of a communication channel calc its maxm
transmission rate in kbps when affected by white Gaussian noise
what is a µcontroller
no of components in VLSI
what is done in VLSI
what are the procedures for sampling of a signal
which is the most commonly used non-impulse type of pump
how do you go from time domain to freq domain(both fourier
and laplace were in the options)
what is thyristor
what is triac
diff betw triac and SCR
why is equalizing ckt used in series with SCR
what freq crystal should be used betw pin 1 n 2 of a µP
if for a resistive load in an SCR ckt the current is ripple
free and equal to 20 A what will it be when 20 mH inductor
connected to the load
if load current in an SCR is I, what is the average
thyristor current for a 1-f converter
maxm efficiency of AM power
given signal freq and intermediate freq calc image freq
when are equalizing pulses applied in TV
what is a spirometer
what is used to measure heart sounds
minm duration of firing pulses for a thyristor
which of these transforms is also called tustin ’s method(
or something like that)
why is RC snubber ckt used
what type of waveform produced by RC oscillator
diff betw inverter and oscillator output
for a 6 phase 60 Hz half wave rectifier what is the triple
freq of the output
which of the following modulation is digital: PCM/ PAM/ PWM/ PTM
which method of ctrl removes offset
eqn of PID
what filter used for extracting SSB output
CMRR is expressed commonly in
integrated value of step fn.
differentiated value of const fn.
what is the kidney dialysis method(artificial) called
quantity analogous to current in pneumatics
quantity analogous to mass in rotational motion
which of these theorems not used in filters( ans: norton’s
theorem)
which of these is UHF(1.68MHz,16.8Mhz,168Mhz,1680MHz
| Is This Answer Correct ? | 5 Yes | 2 No |
Post New Answer View All Answers
how do link aT1 from the 1st BTS to 2nd BTS4?
explain how does frequency affect the size of smps?
what is an excitation table?
hello sir, could u plz send me a sample placement paper for hpcl trainee engg exam..(electronics stream)...hoping to hear from u at the earliest. Thanking you.
• The silicon of a new device has memory leak. When all "0" are written into RAM, it reads back all "0" whithout any problem. When all "1" are written, only 80% of memory cells are read back correctly. What can be possibly the problem with the RAM?
what is E1 ? and how this is work,what is data rate of 1 one E1 and why?
Explain why a voltmeter should be of very high resistance?
Explain the differences between microprocessor and micro controller?
Why opamp called operational amplifier?
How the active power factor correction changes the wave shape of current drawn by a load to improve the power factor?
what is call handover?
HAI HELLO EVERYBODY, GOOD EVINING. THIS IS ANIL KUMAR. IAM WORKING AS A OSS-SR.ENGG IAM LOOKING FOR LEARNING TELECOM PROTOCOLS. PLZ HELP ME. HOW COULD I GET INFORMATION AND MATERILS.
how many types of thyristor are? shortly define them with purpose, application & working principle?
box1-a box2--a box3-a-1 in 3steps using any operation get a*(a-1)-(a-1)*a in box2
State the de morgan's theorem?