Answer Posted / bhavin
a good electrical engineer can modified existing electrical
equipment compare the other one. and i belive that nothing
is possibe with out electrical engineers.
| Is This Answer Correct ? | 1 Yes | 3 No |
Post New Answer View All Answers
What do you mean by dependent and independent voltage sources?
How to calculate the size of earth cable to earth the neutral of UPS ?
Explain about Leakage Test.
A 3 phase transformer's (Y-Y) Y and B phase is (Y and B connection not broken) broken from neutral and R and Nutral connection is ok, what will be the relay tripping and why
can we choose current transformer secondary, to calculate residual flux in a power transformer, so as its saturation is close to the saturation level of power transformer?
State angle criterion.
Which device is used for the source of emission of electrons in a crt?
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
Why in metering Ct for ammeters ct secondary side is grounded for each Ct but not in case of CBCT (Core balance current transformer)..kindly some1 highlights the reason..is it because net flux is zero?
What are the causes of unbalanced current on 34.5kv feeder Ia=0.05,Ib= 0.25, Ic=0.15 and In=0.27 prior to tripping current are balance?
Which material is used for the core of a transformer and why?
if the motor rated speed is 950rpm. how to change the above rated speed? is it possible?
What is the polarization index value ? (Pi value)and simple definition of polarization index ?
If we want to change a contactor of faulty one what are the conditions want to fullfil
In 90 kva alternator that produce the output voltage is 115(p-n),200(p-p) at 1500 rpms means what ampere it produced ?
