Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / balaji
In electrical regulator by using resistance the output
voltage is varied simultateneouly the speed is varied...
But to reduce the the energy loses in the resistor,
electronic regulator is introdueced,which uses triac to
vary the output voltage by varing the firing angle.Which
avoids lose of energy in resistor...
| Is This Answer Correct ? | 155 Yes | 17 No |
Post New Answer View All Answers
In our plant we have installed new MCC with ELR and CBCT which is detecting some leakage current in the system but it leading to some confusion when to check that in which feeder which is drawing current we put off the whole panel itself but still CBCT detecting some leakage current so can anybody ans me , where i am going wrong or how to detect whether its actual leakage or CBCT malfunctioning.
Differentiate between magnetic field and magnetic flux?
How LT megger works ?
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The rotor reactance at stand still is A 2 ohm B 1.25 ohm C 3.15 ohm D 2.25 ohm
A 500 V shunt motor runs at its normal speed of 250rpm when the armature current is 200A. The resistance of the armature is 0.12 Ω. Calculate the speed when a resistance is inserted in the field reducing the shunt field to 80% of normal value and the armature current is 100A.
why constant voltage transformer should be start without load? and if started then what will happen?
How to find out damper winding failure for synchronous machine?
A 7 storey building has a floor area of 35,000sq.ft on each storey. On the ground floor 11KV electrical sub-station is to be erected. A load of 3kw for every 400sq.ft (p.f is 0.8) is proposed for each floor. fire pump 7.5hp, water pump 5hp, lift 2 nos, each 10hp and 20shop load of each shop is 5kw. calculate a. load each floor b. total load of building c. L.T feeders for aech floor and from transformer to main. d. distribution diagram e. capacity of sub-station/capacitor bank f. line diagram
what is deffrence between squirral cage and wound rotor in IM?
Advantage of LT panel vs HT panel
Hi My dear all Friends, There is a question regarding HVAC Engineering and widely used in Power Projects. Question- What is the diffrence Between REF, SEF and Differential Protection....???? Where REF - Restricted Earth Fault SEF - Senstive Earth Fault.
WHAT WOULD BE THE FORMULA OF WIRE GAUGE FOR A FULL LOAD CURRENT
how many synchronous motor are there in any power plant
In 11/0.414 KV Parralel supply network with Bus tie closed what will be the fault level is it doubled or halved??
What is knee point voltage?
