Interested to Buy Any Domain ? << Click Here >> for more details...
why a pure inductive circuit has zero power output?
- 8 Answers
- 20021 Views
- I also Faced
- E-Mail Answers
Answer Posted / abbas
in pure inductive ckt resistance will be zero meance
there is no energgy dissipation so o/p will be zero
| Is This Answer Correct ? | 8 Yes | 10 No |
Post New Answer View All Answers
what is meant by neutral compensation factor and where it is used
A system absorbs 100 k J of heat and the increase in its internal energy is 100 kJ; the work done is
We have a couple of oil tanks at our plant. One of them does not have a lightning arrester installed. My question is it necessary to install an arrestor on every tank or will this particular one be covered by the arrestor installed on the ajdacent tank, Since all the tanks are close to each other. Basically, I want to know that if these arrestors or protection works in a parituclar area of effect or influence. Thanks
How many types of probe used in cro?
can any one provide me a connection wiring diagram for a DG set control panel along with BOM?
What information we need to prepare relay coordination chart
where was current transformer protection units used and why??
what is the use of the puls transformer in UPS & how it works???????????
What are the basic elements used for modeling mechanical translational system?
how you configure motorvision relay (L&T make)from DCS
How should i design a 1ph & 3 ph transformer. Kindly let meknow all steps and formulaes related to design from scratch.
I am having dual speed motor of cromton greaves make of 3.7 KW -1400 rpm and 5 KW - 900 rpm. Please let me know groups and winding connction for rewinding purpose.
How is efficiency of DG set calculated? At many places I found the efficiency to be mentioned in percentage. But at some other places I found kWH/ litres. I want to know how dimensionless percentage value is arrived at?
Please explain the following and how these are working with PLC unit 1.I/O Module 2.I/O Device 3.Adaptor Card 4.Ribbon Adaptor 5.RS 485-FC
How do we calculate over and under frequency tolerance from generator data?
