How to connect frequency meter in metering circuit?(single
phase and three phase frequency meter)phase to phase or
phase to neutral
- 7 Answers
- 34198 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / rvg.msceb
Frequency meter need to connect parallel with the circuit,
as its a sensing device.
there is no such 3 phase frequency meters, measuring from
one phase is more than enough.
| Is This Answer Correct ? | 73 Yes | 6 No |
Post New Answer View All Answers
how do you test tachos and servos
how we can decide that what value of ht line will come to any commercial building? (ans except According to the building load)
what is the reqirred voltage in HT motor to get full RPM on no load test?
Is potential difference materials property ..? if yes tnen how.. explain brifly.
what can be the causes of capacitor start motor having a higher current that its actual
what is meant by 3rd hormonics ?
What is the effect of pd controller on system performance?
need to make a report. Need to choose a 3phase induction motor. Load conditions motor will operate in : Maximum Load: 30 Kw Speed: 2950 rpm Ambient temp: 20 cent Supply voltage: 440V Frequency: 50Hz need to look for the safety factor when choosing the motor, went through catalouge found a few, but dont know how to choose the safety factor allowing an extra load something above 30 KW to avoid any harm.
I am a possesor of c licence from 1993. I forgot to renew during the year 1998. During that time I was working at TNEB to till date. Is there any possibility to get renewed? or to apply for a new one?
HELLO SIR, IAM PREPARING HPCL EXAMS. SO PLS SEND MATERIAL OF HPCL ELECTRICAL ENG..TO VIJAY_8888@YMAIL.COM
i need to give section engineer (electrical engineer) for RRB. Please suggest some book
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
Explain the propagation of harmonics in the network and influence of phase angle of harmonics.
why fractional pitch winding generally used in alternators?
How out of step protection relay works?
