Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / welcome4ujd
A programmable controller is defined as a "digital
electronic device that uses a programmable memory to store
instructions and to implement specific functions such as
logic, sequence, timing, counting, and arithmetic to
control machines and processes"
| Is This Answer Correct ? | 1 Yes | 4 No |
Post New Answer View All Answers
please send the sample qustion paper for iocl written test ..
Good evening all I need a small favour regarding reliance paper i wanna probable sample papers(e&i) of reliance. if any of u have any idea about dis then plz mail me back.i belongs to electronics and instrumentation engg.so i need e&i papers. thanking u....
what is the difference between active & reactive power?
why we r opening HOT BYPASS valve during startup of a compressor?
How to Calibrate Interface Level Troll in field
draw the block diagram of a level transmitter ?
What are the charcterstics of a P&ID controller block for Governor speed raise or lower for a load sharing functionality between 4 Gas turbines in droop mode.
Programmable Logic control.
hello friends, can you please send me the model paper or question paper to be prepared for hpcl examinations????????? You can mail me at rahim_here@yahoo.com waiting for your reply........... help me .. plz.....
What are the materials available to prepare individually for competetive exams in Instrumentation field? Plz reply...
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
Why does a pressure gauge installed on reactor, doesn't have any vent line below to release the pressure? Is it any kind of designing mistake or it actually does not require any vent line? And if it does not require any vent line below it then how we are gonna release the pressure built inside the pressure gauge?
What is eddy current? Describe the operating principle of proximity probe.
Which is the best field foundation bus. ( FF ) Yokogawa, Honeywell or others ?
What are continuances of connecting earthing and shield of branch cables (instrument to Junction box), at the same earthing pot provided on JB? Is it ok, or may produce some problem?
