Answer Posted / k naga muneendra reddy
when AC current is allowed to flow through a solid
conductor, distribution will not be uniform through out the
diameter. current density will be more at surface than at
the center. that's why all bus bars are made of hallow
conductors only not with solid. and also our EHV
transmission conductors are also twisted so that skin effect
is eliminated. not only EHV all electrical cables are also
having twisted conductors inside.
| Is This Answer Correct ? | 8 Yes | 2 No |
Post New Answer View All Answers
WHY THREE PHESE SYSTEM VOLTAGE APPLIED IN 440 VOLT
What is accuracy of a measurement?
WHAT IS LOAD CELL
Why IR value of the (HT cable Plus synchronous motor) is less while individually having IR values in GΩ?
Air refrigeration cycle works on the
how is the testing of an REF relay? what are the test REF circuit having?
In Dyn11 power transformer if any one of the 3 phases connected to earth in star connected side then please explain effect of the current flow in delta connected side of transformer.(In this case if one phase is shorted to ground in star connected side then we observe the current flow in two phases only not three phases in delta connected primary side. Please explain why it is so?)
what is the calculation involved to design the heater to heat 10KL of water in temperature control unit?
what are the main applications of transistor in non-linear region?
what is differant beetween overload current and phase current?
how you taken aotitude test
How DC earth leakage currents can be reduced ?
How to Make relay co ordination chart for a Electrical power distribution of a plant
Can any body tell me about INNER SHUNT COMPOUND MOTOR diagram?
Enlists the applications of sampled data systems?
