whats the diff b/w mpcb and mcb?weather it trips on single
phasing or not.
- 9 Answers
- 14958 Views
- Electra Power, Essar, I also Faced
- E-Mail Answers
Answer Posted / saleem
MPCB:Motor protection circuit breakar(3 phases)
MCB:Meniator circuit breakar (Single phase)
| Is This Answer Correct ? | 14 Yes | 23 No |
Post New Answer View All Answers
how can we say that stator magnetic field rotates with synchronous speed?can we derive?
What is the exact formula for one weber of magnetic flux?
A 50Hz,4-pole,3-phase,star-connected synchronous motor has a synchronous reactance of 12ohmsper phase and negligible armature resistances.the excitation is such as to give an open-circuit voltage of 13.2kilovolt.the motor is connected to 115kilovolt, 50hertz supplying. what maximum load can be the motor torque,line current and power factor?
I have done my m.tech in electrical engg discipline. Can any one please suggest me how should I prepare for getting into phd in iit or nit.How should I prepare for getting into lecturership
sir i used 3 hp of motor for spraying pump, other home light and other home items which size of allminium pvc wire ix used
What is float cum boost charging system?
FOR 16/20 MVA 132/33 KV ONAN/ONAF TYPE TRANSFORMER IT IS DESIGNED FOR 16 MVA WITH ONAN CONDITION.IT BECOMES 20 MVA UNDER ONAF CONDITION.LOAD LOSS IS GUARANTEED FOR 65KW AT 20 MVA AND % IMPEDANCE 13.75. PLEASE TELL US AT WHAT LOAD LOSS AND % IMPEDANCE IT SHOULD BE DESIGNED FOR 16 MVA AND WHAT WILL BE ITS EFFICIENCY AT 20 MVA?
If oil and air can withstand a high MeV when used as an insulator in a transformer, what are the values of how high for each material?
What is creepage distance..... what will be the value for different voltage level
how to calculate IR value of 33KV cable ??
To prove the capacity of a 10MVA transforemr with 6.5% impedance by a short circuit test how much power is needed to inject an impedance voltage if we have to arrive for its rated current?
What is ramp signal?
Terminal blocks is used for segregate the connections... There is any principle for terminal block..?
how to do the ductor test?
Can you please explain creepage distance in detail, for a 6.6kV cable head what must the distance be and how do you determine it?
