Interested to Buy Any Domain ? << Click Here >> for more details...
what are the safety measure & controls in engine?
- 2 Answers
- 6859 Views
- RRB, I also Faced
- E-Mail Answers
Answer Posted / rvg
Safety means operator safety and engine safety.
For operator safety, there shall be an emergency shut off.
for engine safety, there shall be an overload shut off say
5times above the full load capacity after a specific time.
Controls are, speed control, torque control,fuel control,
temperature control etc.
| Is This Answer Correct ? | 15 Yes | 2 No |
Post New Answer View All Answers
if the motor rated speed is 950rpm. how to change the above rated speed? is it possible?
What is negative sequence over voltage element?
Explain what cmos is and its benefits?
what is static frequency converter?what is the function...of sfc...?
What will be the output voltage of a transformer if it is primarily energized from a square wave voltage source?
What is a dominant pole?
What are the special cables required for explosion proof wiring?
We are preparing another project which involves Waste heat recovery from a 1 MW GE Engine. The Engine in particular gives out flue gas at 487Deg C with a flow rate of 5650 kg/hour and this can be cooled to 180 Deg C. This gives a thermal output of ~ 594 KW that is available for input to VAM via heat exchanger / boiler. Additionally 581 KW will be available from engine jacket water (temperature profile 80/ 80 Deg C and a flow rate of 50m3/hr) Our estimation is that 300 TR of cooling is possible with a suitable VAM machine(s). Please advise what is the most suitable arrangement with maximum TR and min Capital expenditure. plz reply me as early as possible
what are the main faults that occur in stabilizers? How they corrected and resolved ? Types of stabilizers ?
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The rotor reactance at stand still is A 2 ohm B 1.25 ohm C 3.15 ohm D 2.25 ohm
what's the simultenous maximum demand (SMD)..what the diffrent MD and SMD?
What is time invariant system?
how to check avr of dg set of 125kva
sir i had plane to do some project with the base of hopkinson test in AC supply its possible
why there using acb enclosure in big buildings
