Interested to Buy Any Domain ? << Click Here >> for more details...
What is the difference between CRNO and CRGO in an
transformer and what is the advantages of these two.
- 13 Answers
- 73144 Views
- Anchor, CIL, ETA, Kirloskar, I also Faced
- E-Mail Answers
Answer Posted / sunil ulange
CRGO - Cold Rolled Grain Oriented is the material used for
Transformer Windings.
CRNO - Cold Rolled Natural Oriented is the material Used for
Low quality Transformer winding constructions.
| Is This Answer Correct ? | 19 Yes | 41 No |
Post New Answer View All Answers
WHAT IS MEANT BY TV TERMINAL IN 500MVA TRANSFORMER?
how power trnafor from 1 point to another point in bus bar ya transmission line( voltage trnasfer from 1 point to another poin)
why do we measure VIBRATION in -24vdc and why we adjust gap voltage -9vdc to 10-vdc? i am trying to get this information since 5 years, yet i haven't get reliable answer, i hope i can get from you.
dg started in plc mode and load taken later one battery terminal connection will be disconnected by loose connection what will happen for dg and shall we connect battery terminals while dg in load time?
Proviiding the Dedicated N earth and individual Body Earths ,Finally these all looped /Now my Question :- will it not harm in case of Transformer Fault current flows in Dediacted N Earthing to Looped Body Earthing.
I have a relay contact rated at 220v dc which is supplied with a 24vdc from the panel,for it to trip the dampers(24vdc).What if the application of the relay changes so that it should work at its rated 220vdc then will it work at 24vdc supply given or any other consideration needs to be taken .....
Determine the BTU size of an aircon for 20 sq metre room
What is the role of feedback in a closed loop control system?
i want to put single phase load on scott connected transformer,eventhough how to balance the transformer.
How to calculate capacitor bank value to maintain unity power factor with some suitable example?
What is instrumental error?
Why we use 4-20 mA Analog signal for the PLC input? Why not 0-20 mA? Why not 5-25 mA?
How to measure the earth resistance value in a concrete pavement(flood light area)?
Can you explain about pole discrepancy scheme
we have provided 30 nos. relay contacts in panel.I want to know how do we do the numbering for the relay contacts as per any applicable standards
