WHAT IS THE DIFFERENCE BETWEEN PLC AND DCS
Answer Posted / anu
1.PLC is for the system which need quick response.Thats why
PLC is for control of a single system with multiple control
loop,i/p and o/p
2.The response time of PLC is in millisec which is much
less than the DCS response time
Is This Answer Correct ? | 120 Yes | 34 No |
Post New Answer View All Answers
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
How many interlocks at turbine? Plz explain briefly
the whole paper was based on Transducers..questions like define repeatability, error,accuracy,precision..den there were many q. on the conversion of Pa to mmHg and other units.. also..der wer few Q. on some level sensors(with diagram)
why we are not using the turbine flow meter in the steam service?
How many are the types of instrument cables in terms of No. of pair.
How does work A temperature valve or fv control valve in process plz brief me
Define the terms Accuracy, precission, Spam, process tolerance while doing calibration of an instrument? Explaini with an example?
centrifugal compressor interlock? Tell me the parameter at which compressor will trip
what is compensation? temprature & pressure
What are different types of cable?
How to work togather like sov,limit switch,proxy switch and booster in xv
What is 1:1 redundancy ?
What is the use of temperature compensation?
How can test or measure the probe and extension cable to identify if the problem at the probe or cable or at the driver it self? (pleast notify the measuring method)
What happen if we install my pressure transmitter below the elevation of pipe in natural gas service?