what is the highest transmission voltage in india???
- 49 Answers
- 47632 Views
- Bhel, EIPL, Engineering, Jindal, I also Faced
- E-Mail Answers
Post New Answer View All Answers
If we have 11 kv RYB Phase single core cable near about. Then wht effect and losses
What is the earth treantment procedure?
how to failure indution motor insulation & how to improve heat in motor insulation
What are the special cables required for explosion proof wiring?
HOW TO CALCULATE THE HEAT AND LOAD OF LT-SUBSTATION WHICH CONTAINS 2*1MVA TRANSFORMERS,LT-SWITCH BOARD,MLDB,ACB,BUSBAR,ETC,......?
Why cables and busbar both needed in LT Panels?
what is acceptance test in electrical engineering.
Sir, I have applied for the of Jr.engineer(Electrical & Electronics) & ASST. LOCO PILOT at ALL RRB BOARDS. please send me all RRB Boards solved papers in the year of 2001 tO till date. i requested send me the papers to my id as soon as possible (jet_0991@yahoo.com). (This is very urgent) Thank You,
What are the various types of BUSBAR Schemes? explain each
What is difference between Sample test and Routine test in safety standard?
Please clarify, 1. Is it required to lay two runs of GI wire along with Armoured LT cable if it is laid between one big mains (63Amps TPN SDF) to small main (32A TPN SDF) with proper glanding termination? 2. If the armoured cable with proper glanding is laid from DB to CNC machine, is it required to run two runs of body earthing to the Machine from DB? 3.If the armoured cable with proper glanding is laid from Substation to Hangar, distance is approx. 100 mtrs, is it required to do earthing at shop area though the primary termination at substation is earthed through gland.
How many kw will suply from one db
a starter used for squirrel cage induction motor?
What is dielectric loss?
Damping resistor provided in open delta (tartiary) winding of a measuring PT at the incoming of a MV inverter drive panel is getting heated up. Can any body explain the reasons and suggest the remedy?
