Interested to Buy Any Domain ? << Click Here >> for more details...
What is the effect if power factor is above 1 or unity.
- 15 Answers
- 49176 Views
- NTS, I also Faced
- E-Mail Answers
Answer Posted / arun
Voltage at transformer terminal increases.You can utilise
full KVA of transformer.Electricity company asks to
maintain pf near to unity to reduce the losses in
transmission as the current reduces reducing the I2R loses.
This is why we get incentive on energy charges from supply
company.
| Is This Answer Correct ? | 7 Yes | 15 No |
Post New Answer View All Answers
what is the ms flat constant for calculating earth mat design calculation?
if an insulated power and control cables of a running gas diesel gensets laid direct in an open trench i.e, trench bed is not rcc of a power house in which rain water, spillage water alwas exists and all power control cables remains submerged even when gas gensets of 480 kw each runningin on load. These power &control cables runs from power house to switchgear room through these trenches in which water remains most of the time. pl explain its merit & de-merit
What is vaccum currcuit breaker.define with cause and where be use it device?
If I want to replace a 26KW Slip ring Motor with a Squirrel Cage motor & Drive (for a Hoist Application). How can I approximate the Motor & Drive HP required in new Setup.
what about electrical pannel.? What is meant by plc pannel.?
what could be the RMS value and average value of a 4 phase sine wave?
how we can calculate chiller required ampear?
what is the safety points of vaccum circuit breaker.
State the frequency for rc phase shift oscillator?
What are approaches to tackle sedimentation problem of reservoir?
What is the maximum number of swithes that can be connected in series up to down stream point in an LV Distribution system?
What are the advantages of the three-phase motor over single phase motor?
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
what about SAP/MRP regarding manufacturing of electric motors and all drives?
Is there a standard depth of gravel fill in Substation Switchyard? Please give a design/drawing. Thank you.
