Answer Posted / vikram pandiyan
if a conductor has a large dia ,then the curent flow will
be limited to the periphery of the cinductor .hence the
effective resistance of the wire is increaded .this will
cause heating and hot spots along the periphery of the
conductor and damage the comductor.
| Is This Answer Correct ? | 11 Yes | 3 No |
Post New Answer View All Answers
how to calculate transformer load?
model question paper for supervisor trainee
How to test IR testing & magnetic balance test
What types of question are done for diploma students in aptitude test
how to electrically make connection to ferroli GN2N?
how to calculate the mesh earth network resistance in such substation, is there any recommended resistance values with references , thanks!
The electrical energy required to raise the tempreture of a given amount water is 200 kwh. If the heat losses are 20%, the energy required is?
to vary valtage from 0 - max a variac is necessary . so how to design for high power applications nearly about 200KW power
What does the a,b,c of 95a,95b,95c relays denotes?
How much load can take a 16 mm aluminum cable 3 phase
Hello Guys !! i want to rrb section engineer electrical(signal) previous model papers? any body help me?
WHAT IS DIFFERENCE BETWEEN CAPACITOR AND CAPACITANCE?
Dear Brother can u tell the proper size selection of cable & the fault level calculation of braker, busbar etc. pls mail me at azeemk30@gmail.com
What is the test block protection relay if any body know plz explained
how to measure the transformer resistance values(dyn11)?and howmuch the minimum value?
