Interested to Buy Any Domain ? << Click Here >> for more details...
why dc power can not be used in transformer?
- 33 Answers
- 69341 Views
- GE, Sail, I also Faced
- E-Mail Answers
Answer Posted / syed shareef
the nessacity to produce emf there must be change in flux.
in ac the sine wave changes with the time so resulting flux
also have time change due this emf produce.
but in dc there is no change in flux or there is no change
in time with wave so it unable to produce emf with it self
if any other means you are going to rotate or too fro
motion then you can produce emf
the law is used is fredays law of electromagnetisum
| Is This Answer Correct ? | 18 Yes | 3 No |
Post New Answer View All Answers
The height to which the liquid in a tank to be maintained for a certain constant velocity?
What is the formula to calculate the rating of a three phase air circuit breaker
Explain Need of a starter in a dc motor.? Also explain any two starting and speed control method of dc motor?
I want formula to calculate cable size as per load given in length & amp. I searched many sites but didn't right answer. Please reply me asap.
Don't you have similar question banks related to Oral Certification Examination conducted by Mercantile Marine Departments / Directorate of Shipping, Ministry of Shipping for Electro Technical Officer?
how calculate gd2 of ht motors
low frequency protection why recomend?
primery try cell?
Why let through energy not considered for ACB breaker while cable sizing?
Define peak time.
I just purchased a 4 position cam switch to be used to operate a 3-speed blower motor. The motor is a 10 amp motor and has 3 wires that are used to control speed. The cam switch was rated at 660V 20 amps but when I received it, I noticed that it has AC-15 operational current rating (Ie) of 4/5 amps. If I am reading the label correctly. the 4/5 amps is related to 440v/220V (Ue). Other ratings are AC-3: 5.5A, AC2: 7.5A and AC-4: 1.5A. My questions are 1) Is it safe to use this switch with the motor I have 2) what is the difference between the 20 amp Ith ratting and the Ie operational ratings?
In power transmission using open belts or horizontal shafts it is preferable to have the slack side of the belt on the top because
What is the basic of DTH.
WHAT ARE THE DATAS REQUIRED FOR PROTECTION AND METERING AND CONTROL AND LOGIC PREPARATION,HOW TO STUDY THE PROTECTION AND METERING?
1) What are your personal strength? 2) What are your personal areas of improvement? 3) What are your expectations from from a particular job? 4) what are your carrier objectives?
