why dc power can not be used in transformer?
- 33 Answers
- 61687 Views
- GE, Sail, I also Faced
- E-Mail Answers
Answer Posted / jaya bharath reddy
generally, transformer o/p is come by mutual induction i.e,
flux produced in primary coil causes the flow of current in
secondary coil. mainly, flux is produced by time varying
fields i.e, ac signal since the ac signal is time variant
but dc signal is time invariant signal it is constant all
the values of time . so, flux is not produced in the
primary coil consequently no flow of current in secondary
coil.
THANKS FOR STUDING THIS EXCELLENT MATTER .PLEASE
GIVE THE EXTRA INFORMATION THAN THIS.
ALL THE BEST!!!!!!!
| Is This Answer Correct ? | 61 Yes | 13 No |
Post New Answer View All Answers
dc supply given to dc generator winding.how is possible? my knowledge is saying the winding will burn. please reply.
how to select the automotive wire size by mathematical calculation. for xenon headlamp with ballast. the ballast given data voltage 10-17v,current permenant 6amp, run up phase is 15amp, peak at swicth on max 400micro sec is 40amp.the sum of cable resistance is 150mohm.please provide referenc document if any for relating the peak at switch on current,time & wire wire size
How will you utilise electrical power? You can start from the generating station.
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
What do you mean by cogeneration? What its working principle?
how is the incoming cable size calculated for a given current rating of a panel??
Explain about 3 phase motor fault current calculation with examples?
What is a fuse? How does it work? What are materials used?
control & auxilary circuits used for circuir breakers
how we test a 3 phase motor on single phase supply....? HOW WE RUN A 3 PHASE MOTOR ON SNIGLE PHASE. supply for testing..? how we verify of a 3 phase motors 6 wire & name thame a1/a2/a3..b1/b2/b3 and c1/c2/c3 for connecting star delta starter ........i have only 1 phase supply ? help forum..........
What is the need of earthing transformer for delta side of a transformer. (Think of a line section between a star/delta transformer at a grid substation and delta/star transformer at a village. An earthing transformer is there at the delta side of the star/delta transformer at grid substation). As there are no ground reference there will not be fault current if a one phase is grounded. Further L-L phase will be sensed by the primary side of star/delta transformer as a L-G fault. So why an earthing transformer is required at delta side
WHAT IS MEANT BY INSULATION CLEARANCE IN VACCUM?
What is the Load Capacity of Panther conductor (0.2) and dog conductor (0.2)
What will be the current if the resistance total in a series circuit doubles?
