Interested to Buy Any Domain ? << Click Here >> for more details...
in three pin pluge there three pins one is phase and second
is earth third is nutral why nutral high diameter compare
with phase and earth
- 10 Answers
- 18841 Views
- Radiant, I also Faced
- E-Mail Answers
Answer Posted / tarun aggawal ymca
actually earth socket has large dia becouse when short ckt
occur the large current flow through this low resistance path
as R = P*l/a as area is large smaller is resistance and
excess will the current flow through it
also if the socket is small we have such a large current
flow throw it and a large heat is produced which will damage
the pin because if area is small heat per area is large and
pin get melted as like a fuse
| Is This Answer Correct ? | 19 Yes | 5 No |
Post New Answer View All Answers
What is speed mode?
how to find out cable size if load is 2800 watts, 230 volts AC supply and load distance is 1800 meters
Is single load(eg: three phase motor) having all the components like positive,negative,zero sequence components during fault condition?
how to determine Sq.mm size of finolex power cables.
If i have two 3000 kW motors and the whole facility requires a 10 MVA transformer. What would be better installing two 5 MVA transformers(one for 1 motor ) or just a single 10 MVA transformer for both of them. Give reasons for your answer.
If one lamp connects between two phases it will glow or not?
It is desired to flood light the front of a building 42 meters wide and 16 meters hig.Projectors of 30 degree beam spread and 1000 watt lamps giving 20 lumen/watt are availabl.If the desired level of illumination is 75 lumen/m and show a suitable scheme.Assume the cofficient of utilization, deprecitation factor and waste light factor are 0.4, 13 and 1.2 respectively.
11KV AND 22KV NETWORK KW CAPACITY IN RING AND RADIAL?
What is the criteria for selecting the voltage classes of an AC Induction Motor.The KW rating above/below which ht/lt selection is made may be provided in details.
I Want randstand placement papers
15hp motor wound by 0.9mm & 0.95mm magnet wire. at no load test it draw 4.2A current. Another motor with same condition draw 9.2A current. How can that occur? pls help
how a flip flop can be used as a latch?
solor panels arrange some angle,panel is flat fitted energy was produced or not why?
The electrical energy required to raise the tempreture of a given amount water is 200 kwh. If the heat losses are 20%, the energy required is?
An ELHNC 80amp 240v 30mA RCD is tripping periodically, every 30 - 180 seconds is it safe to disconnect the protection circuit?
