what is the function of breather in a transformer
Answer Posted / rvg
Breather are used to absorb the moisture content from the
sucked air, while the transformer oil gets expanded due to
heating. Breathers make use of silica gel coloured with
brown used extensively in power transformers.
Is This Answer Correct ? | 233 Yes | 51 No |
Post New Answer View All Answers
what is saturation kit?which use above 15 kw motors panel side.
how tto ingress mw in turbine explain.procedure ?
In EB metering we face problem kva jump even in no load condition.can any one help to control this
what is meant by carrier aided trip protection in transmission line
we have require a Motor (1500kW, 6.6kV, 50Hz) which shall operate at 1500rpm during 30min and after it shall run on 500rpm during 15min. The same cycle shall be repetitive during the whole working days. Which method is best and economic to achieve such type of task. VFD, VVFD, Pole changing motor etc.
how to avoid electrical shock how capacitor store charges wat are the speed control of induction motors state faradays law flemings left hand rule what is rotary converter wat is transmission and distribution what are the sources of energy abrevation of acb,vcb,sf6,igbt what is output equation of transformer which test copper iron and iron loss are calculated what is eddy current draw a single line diagram (10 marks) draw direct online starter(10 marks)
What are your future plans for the company if permanently employed?
Why insulation level follows this order? transformer < bus bar < circuit breaker & Isolator < transmission line.
describe the A.C. Generator Testing procedure
What is the function of auadag in a cro?
what is the principle of operation of tungstun bulb ??
What is the rating of a circuit breaker needed for 300 kv load in 33KV supply line of 33/415 transformer ? Whether 800/1200 amp vaccum circuit breaker can perform for a 33 KV line in input in 415 volt in output of the transformer ?
Block diagram of Power line communication?
What are the advantages of thermal power plant?
What is the efficiency during maximum power transfer?