in three pin pluge there three pins one is phase and second
is earth third is nutral why nutral high diameter compare
with phase and earth
Answer Posted / soma
ok
| Is This Answer Correct ? | 1 Yes | 18 No |
Post New Answer View All Answers
How stabilizer works??
H.t motor 6600 volt to same motor lt supply 440volt supply applyed to h.t motor to effect....
In case of HV test on medium voltage cables, BS is asking for 4 U0 where as IEC is asking for 3.5 U0. Can any one advise me how this 3.5 times or 4 times U0 is derived?
What is the type of earth fault protection used in battery? explain.
A 50Hz,4-pole,3-phase,star-connected synchronous motor has a synchronous reactance of 12ohmsper phase and negligible armature resistances.the excitation is such as to give an open-circuit voltage of 13.2kilovolt.the motor is connected to 115kilovolt, 50hertz supplying. what maximum load can be the motor torque,line current and power factor?
Hi I'm doing my MBA(3rd semester).I applied for the post of ET conducted by BHEL the last year.I cleared the written and lost in personal interview.Again I wrote the exam this time and cleared the written n yet to take the personal interview.Shall I disclose in the interview about my studies.What shall i say if they ask about my change from studies to job
how to calculate the earth fault current
State how to produce a constant rotating field by application of alternating currents to stator armature of a three-phase squirrel-cage induction motor
what is the voltage rating of chiller unit sensors
my question is how to answer the question "you are from b.tech eee background and why do you want to go for banking
What happened when capacitor connect series in ac circuit?
in general it is observed in power stations, the tertiary winding is used in higher rating Y-Y auto transformer but not in Y-Y power transformer. is the tertiary winding is compulsory then why it is not using in power transformerÂ
In the magnetic fluxes, what is the role of armature reaction?
8. A DYNAMOMETER TYPE WATTMETER RESPONDS TO THE.......
anyone please send transformer parameter design formulas & details of tap changer ? plz i have interview this week its more helpful for me ?