Interested to Buy Any Domain ? << Click Here >> for more details...
What is the use of conservater, bucchos relay, breather in
a transformer?
- 8 Answers
- 27279 Views
- Bosch, Wipro, Zadco, I also Faced
- E-Mail Answers
Answer Posted / rvg
Buchols relay is to protect the winding from over heat, and
the circuit will be tripped off as soon as the coil attains
a pre determined temp.
Conservator is to store additional cooling oil, and same
oil can be make use later also.
Breather is to absorbe moisture contents from air which
sucks in while the oil get expanded.
| Is This Answer Correct ? | 90 Yes | 22 No |
Post New Answer View All Answers
Transformer cores are laminated in order to A simplify its construction B minimize eddy current loss C reduce cost D reduce hysterisis loss
What is marx circuit?
HI....HOW CAN BE MESARED THE VALVE OF NEUTRAL GROUND RESISTOR WHIC IS LOCATED AT SWICHGEAR ON GENERATOR SIDE....
State thevenin’s theorem?
10 tube light connect in mcb breaker.one tube light is fault.so breaker is tribe.how fault is rectified.(using 3wire phase,earth,neutral)
What does a Bode plot tell you?
What is meant by cold loop test in instrument
why we use Test Terminal Block in 11 KV and 33 KV electrical panels.
Why we are going for converter transformers for DC drives application instead of distribution transformer?
What is minimum permicible value of leackage current for LT Panle when applying voltage up to 3 KV for 5 Minuits?
IF I KNOW THE AREA OF CROSS SECTION OFTHE WIRE , WATTAGE OF THE LOAD ,VOLTAGE SUPPLY WHAT IM GIVING TO THE LOAD AND ALSO POWER FACTOR OF LOAD ....... SO GIVE ME FOR WHAT AMOUNT OF CURRENT I SHOULD USE WHICH TYPE OF CABLE?
What will happen to the protection and metering, if the polarity of a single or two PT/PTs in three phase system is reversed? Please provide reference if any.
hi frenz,its aswathy.i hve aplied for the hpcl test on feb,pls send the test patern & the placement papers as soon as possible. mail-id :kjaswathy@gmail.com
Terminal blocks is used for segregate the connections... There is any principle for terminal block..?
What is the difference between diode and a transistor in terms of the direction of current flow?
