what are the highly demanded courses for electrical engg.
who finished his b.tech
- 2 Answers
- 4442 Views
- I also Faced
- E-Mail Answers
Answer Posted / vikramsena_reddys@yahoo.com
If u finshed B.Tech u better to learn PLC, SCADA, MMI and
Drive Control courses.These are very much demanded in core
industry. or other wise u better go to Embedded, Vlsi.
| Is This Answer Correct ? | 9 Yes | 1 No |
Post New Answer View All Answers
what is size of 3phase 4wire cable to be used for 11 ton ductable A.C and how to calculate cable size for different load
How many wall/floor flange will i use in bus duct system if we have in our design a 35th floor building.
How many Zones can be in Conventional type fire alarm system & how can we detect the fire in Conv. type FAS?
what is the Pickup/drop off ratio in BCPU relays
Can anybody post questions asked in Engineers India Limited Interview? Thanks in advance.
what is the difference between electrical and electronic choke?
IF alternator SCR value will be high means what happen in alternator efficency at operating power factor of 0.8
can we do the star delta connection of capacitor for 3- phase motor starter.
When we have earthing mesh or underground earthing network in industrial plants, weather we have NT-S or NT-C-S kind of earthing system, so eventually weather we must use 4 or 5 wire in 400 volt level (For example 3×150+70 mm2 or 5×150 mm2) in this connection I would like to know exactly the paragraph of IEC or IEEE number
Define coil span?
State norton’s theorem?
when we have to purchase the transformer by own i.e how much load will preferred HT connection?
The ripple frequency in output of fullwave bridge rectifier is a. Half the input b. Twice the input c. Same as input
We have two parts in generator, electrical & mechanical. how it works?
please send me the L&T Emb. sys. placement papers and entire details of pattren
