Interested to Buy Any Domain ? << Click Here >> for more details...
How do you select a cable size(Cu&Al) for a particular load
- 10 Answers
- 33512 Views
- Adhunik, BPCL Bharat Petroleum, Hiecon, TATA, I also Faced
- E-Mail Answers
Answer Posted / tauseef tarique, engineer(e)
depending upon full load current of the load, the size of
cable is selected. Also calculate the % voltage drop and
see it is in permissible limit or not if is more select the
next highier size of cable.
| Is This Answer Correct ? | 34 Yes | 9 No |
Post New Answer View All Answers
WHERE CAN I GET THE PREVIOUS QUESTION PAPERS OF Govt Polytechnic in deee 2nd year papers
Who many reason of ignition fail ?
How to prepare electrical preventive maintenance plan & shedule of machine tools in manufacturing unit.
What is the unit of attenuation?
what shoud be strength and weakness to impress interviewer????????
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
What will happend if given Vfd out put to step up transformer
why we use single core 630mm2 cable for transformer secondary side
When we use air circuit breaker, it has O/L protection ,time delay SC protection, Instataneous SC protection & ground fault protection. They all have some setting range. But what is the suitable/allowable setting for the above protection which will be safe for the equipment? For example-O/L protection setting have a range of (0.4,0.45,0.5,0.55,0.6,0.65,0.7,0.8,0.9,1.0)xIn Time delay SC protection have a range of (1.25,1.5,2,3,4,6,8,10,12)xIn Time delay setting is 0.02,0.1,0.2,0.3,0.4 Instataneous setting is fixed to 20xIn Gound fault setting is given 100A,300A,600A,900A,1200A This setting are for 2500A ACB. So what will be the basic allowable setting for the above protection? is there any formulae to calculate this<
How do the synchronizing lamps indicate the correctness of phase sequence between existing and incoming alternators?
please send me RRB electrical engineer previous year questions for Sr. Section Engineer
why Induction Generators are not "Black start" ? and apart from WTGs where this types of generator are generally used?
what is meaning of bus riser
Circuit diagram of tube light without starter using electrical choke
how power trnafor from 1 point to another point in bus bar ya transmission line( voltage trnasfer from 1 point to another poin)
