If single phase voltage level is 230V than why three phase
voltage level is not 660V ?, but it is only 440V.
Answer Posted / sunny
because the voltage is measured between the two terminals
only in 3 phase we are measuring it between 2 lines that is
why it is 440 and not 660
Is This Answer Correct ? | 132 Yes | 41 No |
Post New Answer View All Answers
WHAT IS DOL STARTER? HOW IT WORK? GIVE ITS CONTROL AND POWER DIAGRAM .
how to get electrical supervisour certificate in gujarat
r we are using in gas turbine mark (5) frame (6) (made in india Bhel 1997) Ā
What is pole of the system?
What should be the voltage between Neutral and Ground in secondary side of the step down transformer (230 V to 110 V) with no load condition?
what is conductor constant of raccun conductor
What is the vector group of a transformer,how can it be found out?
what is the difference between directional & non directional earth fault with example please explain.
how we will deside the high voltage value
The magnitude of sum of two sinusoidal av voltage is equal to 230 volt.the magnitude of each individual voltage is also equal to 230 volt.what must be the phase difference between voltages?
How to test the vector group of a Yd11 transformer? what are the relations to be checked between various vectors to confirm this vector group?
in wind mill use 2100 kw asychronous generator ( induction generator ) rotor voltage : 3300,stator voltage : 690, rpm : 1511 type : MRL063E04 ' we check rotor resistance magger value found following. R-EARTH - 00 M.OHM,Y-EARTH-34 M.OHM,B-EARTH- 33M.OHM R-Y: 31 M.OHM, Y-B: 00 M.OHM,B-R :33 M.OHM HOW CAN I TAKE DECISION?pls ans. quickly
Draw the vector diagramme for Asynchronous Induction Generator at noload,half load and fullload.
can we conduct the swineburne's test on a dc series motor? why?
why we use 630mm single core cable for transformer secondary side and why two neutral cable