Interested to Buy Any Domain ? << Click Here >> for more details...
what is the meaning of bus bar, in electrical panels.
- 13 Answers
- 50260 Views
- HLG Habtoor Leighton Group, I also Faced
- E-Mail Answers
Answer Posted / tauseef tarique, engineer(e)
Bus bar is Aluminium or copper flat/strip installed inside
any panel for carrying current. Incomming suply comming
into the panel through incomer (VCB/ACB/MCCB/MCB/Isolator)
and connected to this busbar. To this busbar all outgoing
feeders are connected via breaker.
The busbar may be in LT or in HT panel.
| Is This Answer Correct ? | 97 Yes | 7 No |
Post New Answer View All Answers
what are the differant std sizes of cable trenches?
Can we use BS 6651 and BS EN 62305 standards for computer room lightning ptotection in substation?
What is “pu” in electrical engineering?
Please clarify, 1. Is it required to lay two runs of GI wire along with Armoured LT cable if it is laid between one big mains (63Amps TPN SDF) to small main (32A TPN SDF) with proper glanding termination? 2. If the armoured cable with proper glanding is laid from DB to CNC machine, is it required to run two runs of body earthing to the Machine from DB? 3.If the armoured cable with proper glanding is laid from Substation to Hangar, distance is approx. 100 mtrs, is it required to do earthing at shop area though the primary termination at substation is earthed through gland.
why zero sequence impedance measurement is not applicable for single phase GT
why the protection turbo generators is most complex?
HOW MUCH CURRENT DOES SYNCHRONOUS MOTOR TAKES AT SYNCHRONOUS SPEED IN NO LOAD CONDITION ?
i am trying to PSUs/govermeant jobs since last 2 years but still i m not success, plz help me.
why Lightning arrestor are made by 2 seperate stack of inslutor but why cvt are in single stack of insulator.
how to extend relay operating timing in 24V dc relay card (without using Timer )
What is a feedback in control system?
how can I calculate charging current of cable/overhead conductor? what is roll of voltage in it ?
I have 4 busbar of 1000 ampere. we use 4 busbar to make 4000 ampere in one phase.my problem is that when we applied 60% load on that then busbar produced high noise.what is the reason of that and how can i minimize that noise.
I am shobana from Chennai. I am having my personal interview on 19th Dec at Chennai.kindly mail me the questions to mail id shobana.shanthi@gmail.com
If I want to buy a new Xformer for my plant what are the main parameter will I need to check?
