Interested to Buy Any Domain ? << Click Here >> for more details...
tell 2 reasons for why only copper is used in domestic
wires& only alluminium in transmission lines ?
- 10 Answers
- 18056 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / lakshman
1. copper has better conductivity than alluminium.good
conducters dont produce magnetic flux that is inducyance of
copper is neglegible.as we domestic loads are operate
nearly unity power factor condition much reactive power is
not needed.so copper is suitable for domestic loads.
but transmission lines have to carry reactive power copper
is not suitable .alluminium is used as its inductance is more.
| Is This Answer Correct ? | 2 Yes | 12 No |
Post New Answer View All Answers
What size cable (based on voltage drop) is required to supply a 40 A three phase boiler if the wiring system is 75V single insulated cables installed in non-metallic rigid conduit 56m from the main switchboard? Voltage drop in the consumer's mains is 8V.
my b-tech percentage is 50%. what answer will satisfy the hr ?
What is a differential amplifier? Also, explain cmrr.
What is the safety of UPS?
why capacitance effect is predominant in underground cable transmission and inductance effect is predominant in over head line transmission?
how braking & making capacity of circuit breaker are calculated?
Define delay time.
Explain the operation of variable frequency transformer?
How to define Kirchhoff current law and voltage law along with simply examples.
How do i perform grounding of star point of Genset (400V) for making connection with step up transformer of DELTA-DELTA (400V to 20KV) ? while Genset itself has its own neutral and grounding bus bar inside genset breaker box whereas we have another neutral and grounding busbar in synchronizing panel next to genset at maximum distance of 6meter, would someone pls advice if we can only perform neutral grounding in synchronizing panel or should we ground neutral on both places inside genset breaker box and synchronizing panel.
salam&hi, i need to know about how can i calculate an enough current for the new building before i submit it to the suppliers
how we arrange the hv side with delta connection in case 33/11kv of transformer.
How to calculate energy stored in an inductance?
Give some example of fault limiting devices?
State uses of different types of stsrters with different capacities of motors as below: a. up to 5HP b. above 5hp to 10hp c. above 10hp to 20hp d. above 20hp
