Interested to Buy Any Domain ? << Click Here >> for more details...
Why we are mostly using a single 3-phase transformer
instead of three 1-phase transformers?
- 7 Answers
- 12502 Views
- I also Faced
- E-Mail Answers
Answer Posted / debashis das
Any where(motor,dianamo etc) using 3phase instead of 1
phase icrease the efficiency of convertion and also cost
saving.
| Is This Answer Correct ? | 5 Yes | 5 No |
Post New Answer View All Answers
HOW MUCH CURRENT DOES SYNCHRONOUS MOTOR TAKES AT SYNCHRONOUS SPEED IN NO LOAD CONDITION ?
sir, what is the importance of Fault MVA. how to calculate fault mva of 33kv substation connected by 6.5 km line(single circuit with equal spacing) with 110/11kv transformer in 110kv susbstation.the fault mva on 11 kv bus in 110kv susbstation is 208mva.
DRAW ACIRCUIT DIAGRAM OF 100 KVA 415V/55-0-55V DELTA TO STAR TRANSFORMER
Draw a SLD of DG distribution up to main LT panel?
What are motor generator sets and explain the different ways the motor generator set can be used ?
which is the most advanced form of SF6 BREAKER?Can we use other gases to quench the arc?
any one can explain the stages of a knee point which is taken during ct magnetising curve.
What are the electrical engineer roles and responsibilities in chemical plant?
What is the role of feedback in a closed loop control system?
sir, Is their any measuring unit of knoking? please explian?
what are the applications of PLC?
how to design the heater in temperature control unit to heat 50KL of water?
What are the differences between single phase and three phase?
what are the industrail measures to over ferranti effect? how would the ferranti effect the power system if those remedial mearsure arent taken? how often does this effect occurs in real power system?
How much kv gas generator is needed to run 2 hp and 1 hp airconditioners, plus a refrigerator and 4 Tvs
