Interested to Buy Any Domain ? << Click Here >> for more details...
In Steam Turbine using superheated steam as an inlet steam,
What happens if I use air in place of steam with the same
parameters ? Will is work or not ?
- 7 Answers
- 15615 Views
- I also Faced
- E-Mail Answers
Answer Posted / ramesh
my opnion
1. specfic heat water is high.compared air.
2 air is poor conductor.
3. what is work done?
changes temperature ie inlet temp-outlet temp
only air is but no changes in temp.
air occupies its more space
| Is This Answer Correct ? | 7 Yes | 2 No |
Post New Answer View All Answers
I need BHEL apptitude questions
What is the formula to calculate how to find the amperes in 1ton and how many btu
what is the difference between type -a and type -b iron > The chemical compostion is given here under and also guide us the effect of Ni;Cr;Mo in the iron; name and use of these two types of iron Type a Type b %C :3.15 2.65 %Mn:0.41 0.52 %Si:1.72 1.60 %S :0.090 0.082 %P: 0.215 0.204 %Ni: 0.40 Traces %Cr : 0.49 Traces %Mo : Traces Traces
What is the importance of thermostat in the cooling system of an engine?
how to define nomenclature of bearing.
What is mean carry over of Aux. Boiler?
CAN ANY ONE TELL ME WHEN WILL CONDUCT ASSISTANT MOTOR VEHICLE INSPECTOR /RTO APPLICATIONS WILL RELEASE
How to find the bearing dimension from its number for ex 24040
Dear friends, i am a student of mechanical final year in rajasthan. If you have any type (Technical,interview, aptitude) of question paper related to BIRLA CEMENT LTD. than plz send me these paper at vinodsainikumar4@gmail.com thanks
Explain the difference between pearlite and cementile ?
How the net work to drive a compressor and its volumetric efficiency behave with increase in clearance volume ?
what is the velocity considering in lube oil drain line for lube of system for steam turbine?
sir can u plz send me Jindal Steel's mechanical engg. paper and the aptitude paper of previous year....i wud be very thankful to u.... my email id..- suraj.candid@gmail.com
Difference ISDN and Brodband?
If a dimension is given as SC parameter, is supplier allowed to use full range of tolerance specified in drawing without proving capability?
