Interested to Buy Any Domain ? << Click Here >> for more details...
Explain the working principle of Vacuum circuit breaker and
Air circuit breaker
- 10 Answers
- 48543 Views
- HP, Trinidad and Tobago Electricity Commission T TEC, I also Faced
- E-Mail Answers
Answer Posted / saju
normally the contacts of CB are closed,when a fault occurs
these contacs are pulled apart hence an arc will be formed,
this arc has to be quenched for successfull
operation.circuit breakers are classified in different
ways,one of the ways is according to the arc quenching
medium.in air circuit breaker the arc quenching medium is
air,and in vaccum circcuit breaker it is vaccum
| Is This Answer Correct ? | 112 Yes | 21 No |
Post New Answer View All Answers
what is sevice settings for mccb?How can be it setted?
Why Stabilising Resistor used in REF circuit ?
Earth is a conductor or load?then ammeter connect to 3- phase supply,it shows the measurents or not?
On a 3 winding transformer YNynd11, how do you apply REF protection to the Delta tertiary winding that is supplying auxiliaries to a substation?
(1)The demand for electricity , the amount of renewable generation available, the amount of fossil fuel generation available and the cost of the fossil fuel generation are shown in table below period(hrs) demand(MW) renewable (MW) fossil- fuel(MW) cost of fossil fuel(MW) 00.00 - 01.00 2000 1800 2000 30 01.00 - 02.00 2300 2500 2000 30 02.00 - 03.00 2500 2700 2100 45 03.00 - 04.00 2900 3100 2100 50 04.00 - 05.00 2700 2600 2500 45 05.00 - 06.00 2400 2000 2700 50 06.00 - 07.00 2200 1800 2000 36 07.00 - 08.00 2100 1600 2000 36 Assuming that the renewable generation incurs zero cost, determine an optimal generation schedule(specifying the amount of renewable generation and fossil fuel generation used in each period, the cost for each period and the overall cost for 8 hours.)
CT Ratio of a energy meter connection is Red Phase : 100/5A, yello Phase : 50/5A & Blue phase : 100/5 A what is the overall Multiplication factor
why do we use spark detector inside the slip ring brush compartment 0ona slip ring induction motor?
if the load is 80 amp for main fuse and 100 amp for breaker so how can we calculate the cable size (cooper ) .
my UPS suddenly goes off and all panel light also blow off.This happens even main electric supply is not interrupted.After some time it automatically starts functioning normally.Batteries are new.
When lag/lead/lag-lead compensation is employed?
typically in power distribution substation. 1- Any idea how would be the graph of capacitor bank consumption verses time through the day . 2- How is the switching ( on and off ) of the capacitor bank, per need?
In the N-series schneider reclosers. What is the difference between current during fault time and current at tripping? This appears in the Event log in an event of a trip out.
what is the transmission loss for electrical supply? specifically a large shopping complex where the grid is half KM away, what will the % of transmission loss? is there any transmission loss for captive unit generation for above set? thanks
my bachelors was done with EEE now i got admit in NU with CS as course. how to answer this qns 1) why u choose cs? 2) why u changed from eee to cs
how to determine the inrush current of a transformer
