Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / a.muthukumar
PLC is a Programmable Logic Controller.PLC is having CPU
and Input module and output module.CPU reads the status of
inputs ,Executes the program logic and Writes the status of
outputs.PLC having some programming languages like Ladder
logic,Function Block diagram,Structured text,Sequential
function chart.PLC is having soft wiring program,If is
required to change the logic is vary easy compare to Hard
wiring.
| Is This Answer Correct ? | 10 Yes | 0 No |
Post New Answer View All Answers
What are different type of instrument cable
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
why we us isolation barrier in hazardous area how it works to protect the area and please clarify its current flow.
Why humidity limit is 30 to 55 % for raw material storage?
Explain pH, Conductivity.
the pump holds on run indication into the dcs and filed local control panel remote push button condition operaton wrong like when the push button pushing conditions the pump is off and the push button release condition the pump is on totally opposite condition . And control room inside give the stop command into dcs just 1secon relay engage and again normal condition. How can I slove
why we use cascade control and feed forward control in 3 element drum level control measurement of steam drum .what is cascade and feed forward control system ?give example .
What is the advantage of using locally fabricated hook ups over Pre fabricated hook ups in process instrumentation?
What is Positive Calibration and Negative Calibration?
what is performance test.need defination
what is the minimum power (P=VI)to produce a spark?
detail of mass flow meter pricipal
i am preparing for BARC ,so plz mail me how to prepare for BARC. ALSO IF POSIBLE SOME RELATED QUESTIONS. MY MAIL ID IS khushi_4uall2003@yahoo.co.in
What are continuances of connecting earthing and shield of branch cables (instrument to Junction box), at the same earthing pot provided on JB? Is it ok, or may produce some problem?
What denotes the 5/8mm in the 3300XL 5/8mm proximitor probe?
