Interested to Buy Any Domain ? << Click Here >> for more details...
every motors written in name plate IP 55 what is this?
- 2 Answers
- 27032 Views
- I also Faced
- E-Mail Answers
Answer Posted / habeebm
IP (Ingress Protection) codes define how well an enclosure
protects against the external environment.
As the number gets higher, the protection gets better.
The first digit defines the protection level
against "solids", the second against "liquids". You MUST
use both digits to define an enclosure.
For the first digit:
0 = No protection
1 = Protected against objects greater than 50 mm diameter
2 = Protected against objects greater than 12 mm diameter
3 = Protected against objects greater than 2.5 mm diameter
4 = Protected against objects greater than 1.0 mm diameter
5 = Dust protected
6 = Dust tight
For the second digit:
0 = Not protected
1 = Protected against dripping water (i.e. vertical plane)
2 = Protected against dripping water up to 15 degree angle
3 = Protected against spraying water
4 = Protected against splashing water
5 = Protected against water jets
6 = Protected against heavy seas
7 = Protected against effects of immersion
8 = Protected against submersion
| Is This Answer Correct ? | 106 Yes | 8 No |
Post New Answer View All Answers
what size steel armoured cable is required to support 1500kva capacity. would 70mm squared be enough or would I need 90 or 120mm squared 3c plus earth
what is the difference between torque induced and torque load?compare them with respect to dc motor?
Why i receive the GCU fault in my DG Sychronization panel . what all the factors considered for this fault .
to vary valtage from 0 - max a variac is necessary . so how to design for high power applications nearly about 200KW power
how to decide choke rating for drive?
Advantages of using generator circuit breaker (GCB) scheme in a power station ?
1.main parts of generator? what is used A-check,B-check,C- check? 2.what is FM200 system in data centers? 3.difference between pac,ahu?
When are the directional relays used?
Is there any guideline say about display of earthing value near to earth pit
What is an alternator impedance value?
What is the minimum underground tank size capacity considered for firefighting purpose?
What are operating procudures & Safety precautions to be observed while operating OLTC in manual mode ?
1.dg on load alarm/stop alarm... 2.dg on load. piu alarm alarm kaise chek krte hai
What information we need to prepare relay coordination chart
If we impress a dc voltage of 230 V on an unloaded 230 V, 50 Hz transformer it wi A give high secondary voltage B burn out C give secondary voltage as per K D none of these
