Interested to Buy Any Domain ? << Click Here >> for more details...
why electric shock due to dc is dangerous than that of ac
- 44 Answers
- 68687 Views
- I also Faced
- E-Mail Answers
Answer Posted / anoop
Many of the people here have simply written things without
knowing what it is. A.C is dangerous because of its larger
peak voltage and its ability to distort our hearts beating
cycle( causing fibrillation). D.C is dangerous because, a
person touching D.C will feel difficulty in leaving as our
muscles contract in one way and the person usually holds on
to the conductor.
But finally A.C is more dangerous.
| Is This Answer Correct ? | 29 Yes | 5 No |
Post New Answer View All Answers
how to find three phase complex power in per unit and MVA?
why induction motors are rated at 0.8 power factor.
Given a collection of points P in the plane, a 1-set is a point in P that can be separated from the rest by a line; i.e. the point lies on one side of the line while the others lie on the other side. The number of 1-sets of P is denoted by n1(P). The maximum value of n1(P) over all configurations P of 19 points in the plane is 18
As an electrical engineer what are the responsibilities which i can hold in TCS?
what is the calculation involved to design the heater to heat 10KL of water in temperature control unit?
what is meant by rotating magnetic filed
How we calculat the NGR of 3phase Generator, Our generation voltage 11KV
can we choose current transformer secondary, to calculate residual flux in a power transformer, so as its saturation is close to the saturation level of power transformer?
why and how current drawn by battery charger depends upon the altitude where it is located?
what is the function of capacitor duty contactor in an capacitor panel???
how r charge carriers produced
i have total 8 dg sets for synchronizing and 2 buscoupler,1 sectoin dg no 1,2,3,and 2 sectoin dg no 4,5,6,and last section dg no 7,8 ....if buscupler no 1 and 2 is off mode ..than dg no 1,2,3,will synchroniz of another dg sets?
Why in 6 KV XLPE cable termination kit used and why not in 380 V xlpe cable same is not used
How can we findout the maximum efficiancy of Transformer? At which load?
how calculate the electrical load for industry and office
