how to reduce power loss when the tranmission under long
distance?
- 19 Answers
- 21927 Views
- I also Faced
- E-Mail Answers
Answer Posted / mani
We have to increse the transmission voltage and current can
be reduced so losses will be less
| Is This Answer Correct ? | 8 Yes | 1 No |
Post New Answer View All Answers
Explain the iniluencc of short circuit ratio on the pert'orniancc of synchronous machine.
how to calculate
What are the no-load losses for the 11000/415V transformer with the following rated capacity? 1.1500 kVA 2. 2000 kVA 3. 2500 kVA 4. 3000 kVA
how can we determine size of a cable by knowing the kw or current rating of a load?how can we calculate the resistance box of a slip ring motor?
Suppose a 3 phase, 2 pole, 440V induction motor is driving a flywheel of 600mm diameter, 150kg mass. By using v-belt and pulley, the speed is increased to 4500 RPM. What will be the effect on motor current?
how to commissioning the genset with amf panel?
is it possible for different brand of H.V transformers to run or operate in parallel to each other? if so how much disturbance can this affact the H.V bus bar?
Can we use a absolute encoder to show rpm of a motor ? what about the condition when power is off ? what is difference if a incremental one is used ?abanirout@gmail.com
Which type of air compressor is used now a days in the market. Keeping in mind of energy efficiency and maintenance points. Relevant documents may also be sent on mentioned email ids.
When we use 3 terminal resistor?
what is metering cum synchronizing panel and how it is used?
at what rate the micro controller increment its timer....is it 1micro seconds or 1/(12*10^6) seconds
Do you know what is dry-out test in x'mer
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
How to calculate the fuse rating depend upon the DC circuit?
